Quadro SW-Version 4.1.x Instalační příručka stáhnout pdf (Strana 24)

QuadroISDN Manual II: Administrator's Guide Administrator’s Menus

QuadroISDN; SW Version 4.1.x 24

Send Test Mail is used to initiate a test e-mail transmission. This button will be enabled if correct values have been submitted and saved on this

page.

To configure the System Mail

1. Enable the system mail sending by the Enable checkbox selection.

2. Update or set the SMTP host in the SMTP Host text field.

3. Update or set the e-mail sender address in the Mail Sender Address text field.

4. Update or set the e-mail address in the Mail Recipient Address text field.

5. Enable SMTP Authentication if it is required on the server.

6. Insert into the corresponding text fields an authentication User Name and User Password defined by your SMTP server.

7. Press the Save button to submit these settings.

8. Use the Send Test Mail button to send a test e-mail with the configured settings.

Firmware Update

This window allows updating the software of Quadro by installing new firmware (image). Users registered at Epygi will receive a notice when new

firmware is available and will be able to download it from the Epygi Technical Support WEB page.

Updating new firmware requires a working power supply. Quadro is provided with a battery (accumulator). If the battery is low or simply absent the

“There is no battery or voltage is low” warning is displayed.

Please Note: Installing new firmware will take about 15

minutes. During this time, QuadroISDN, telephony and Internet

access will be disabled.

The firmware update will cause the loss of the following data:

• All voice mails

• DHCP leases

• Transfer statistics

• Call statistics

• All pending events

• User specific GUI states

The following main processes will be stopped during the

firmware update and will be restarted after the installation is

completed:

• Voice Software

• Network Time Protocol Daemon

• Network Interface Statistic Daemon

• Dynamic DNS Daemon

Please Note: If you consider the

Call Statistics entries in the

displayed tables to be important, it is recommended to

download them from the corresponding page prior to starting

the Firmware Update.

Fig. II-36: Firmware Update page 1

Next will move you to the second page of Firmware Update where the image file should be selected.

The second page of Firmware update has a Browse button

used to browse the image file, and the Specify Image text

field that will display the selected image filename.

Pressing Save will start uploading the image file to the board

and the next page will display results and verification of the

image being burned.

Fig. II-37: Firmware Update page 2

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 105 106

Komentáře k této Příručce

Žádné komentáře

Quadro SW-Version 4.1.x Instalační příručka Strana 24

Komentáře k této Příručce

Související produkty a manuály pro Systémy pobočkových ústředen (PBX) Quadro SW-Version 4.1.x